63000 series DC electronic load
63000 series DC electronic load, mainly used for switching power supply, A/D power supply, power electronic components, adapters, 3C batteries, chargers and some power electronic components. With a maximum power rating of 350W, it is suitable for testing various low-power power products. The 63000 series operates at 150V, with a power range of 250W and 350W, and a single unit with a maximum current of 60A
8020 Adapter/Charger Automatic Test System
The 8020 Adapter/Charger Automated Test System is the best test system for testing adapters and chargers on the production line. The 8020 supports simultaneous testing of multiple DUTs, greatly increasing production line capacity, and combining Chroma 8000 systems. Flexible hardware architecture with a choice of hardware such as AC power supplies, electronic loads, timing/noise analyzers, power meters, etc.
62000H-S series DC power Supply
The 62000H-S series features high-speed 100kHz digital data capture continuous measurement lines and digital filtering mechanisms, and high-speed 25kHz D/A control, which accurately simulates the IV curve and responds to the pull-in power of the PV inverter. When the chopping effect is simulated in the IV curve, the mathematical model of the EN50530 & Sandia solar cell is built in the stand-alone unit
6500 Series Programmable AC Power Supply
This series of products provides programmable settings with voltages of 0-300V and frequencies of 15-2000Hz. The range of applications is quite wide. It can be used for aerospace or military applications (400Hz) in addition to general commercial (47-63Hz) applications. The low frequency output characteristics can also be applied to the testing of low frequency start motors or air conditioner compressors. Outputs a very pure sinusoidal waveform that typically maintains a distortion rate below 0.5%
61700 Series Programmable AC Power Supply
The 61700 Series programmable AC power supply delivers pure three-phase AC power. The user can set the output voltage and frequency arbitrarily, and measure the characteristics of the output and display it on the LCD screen. It provides R&D and quality assurance personnel with a good power simulation tool to test various conditions of the product. It can also be applied to the production line to make automatic test equipment for mass production
61500 Series Programmable AC Power Supply
The 61500 Series Programmable AC Power Supply is a solution to meet market needs. It can simulate various normal or abnormal AC input conditions and measure important parameters of the products under test. These features make the 61500 series suitable for commercial, power electronics, avionics, military and other fields, R&D and quality assurance units for specification verification to laboratory testing, and factory production lines and other test applications
